Experimental and numerical researches were conducted to investigate the cooling performance of a single row of consoles (converging slot-hole) on a large-scale flat-plate model. The results show that the coolant flow from a row of consoles shows good lateral uniformity of adiabatic effectiveness, with regions of slightly enhanced cooling occurring between the consoles. For the console cooling geometry, the interaction between coolant jet from inclined console and the mainstream flow results in reasonable vortices configuration. A pair of counter rotating vortices originate from the edge of slot, not from the centerline of film holes and the rotating direction is contrary to conventional cylindrical hole. The heat transfer coefficient ratio is a little bigger for the console case than conventional cylindrical hole, and the discharge coefficient for a console is larger than that for cylindrical film cooling hole.
A series of computations is conducted for many multi-hole arrangements at several blowing ratios to further investigate the evolution of the film from multi-holes. The influence of multi-hole arrangement on effusion film cooling is analyzed and a preliminary relationship evaluating the film development from developing state to developed state is brought forward. Results show that the coolant jets from front rows of multi-holes merge rapidly and the strength of the kidney vortices due to mainstream-coolant jet interaction in the downstream region are mitigated under super-long-diamond arrangement where the streamwise hole-to-hole pitch is bigger than spanwise hole-to-hole pitch. The holes array arranged in super-long-diamond mode is not only in favor of obtaining developed film layer, but also improving averaged adiabatic film cooling effectiveness.
Three-dimensional numerical simulation is carried out to investigate the flow and heat transfer characteristics of impingement/effusion cooling systems. The impingement/effusion holes are arranged on two parallel perforated plates respectively in a staggered manner. Every effusion hole has an inclined angle of 30° with respect to the surface. The two parallel plates are spaced three times the diameter of the effusion hole. The ratio of center-to-center spacing of adjacent holes to the diameter of the effusion hole is set to be 3.0,4.0 and 5.0 respectively. The flow field,temperature field and wall film cooling effectiveness are calculated for different blowing ratios ranging from 0.5 to 1.5. In general,the wall cooling effectiveness increases as the center-to-center spacing of adjacent holes decreases or the blowing ratio increases.