In this paper we present a novel method to fabricate reliable micro-electro-mechanical system（MEMS） disk resonators with high yield and good performance.The key breakthrough in the fabrication process is a novel approach to effectively restraining electro-chemical corrosion of polycrystalline silicon（polysilicon） electrically coupled with noble metals of MEMS devices by hydrofluoric acid（HF）-based solutions.In addition,a measurement architecture based on a differential readout topology is demonstrated.The differential circuit proposed here can effectively suppress noise and feed-through current by common-mode rejection of the differential amplifier.This differential amplifier circuit configuration is also used to build up a notch filter.The preliminary result about the temperature dependence of the resonance frequency is discussed,and the device failure is analysed.
A new approach based on microcantilevers is presented to detect infrared photons with high sensitivity. Infrared photons are measured by monitoring the amplitude change of a vibrating microcantilever under light pressure force.The irradiating light is modulated into sinusoidal and pulsed waves,and to be in-phase and anti-phase with the cantilever driving signal.A linear relationship between the amplitude change of the cantilever and the light power distributing on the cantilever was observed.Under a vacuum of 10^（-4） Pa,an infrared light power of 7.4 nW was detected with the cantilever.The in-phase and anti-phase modulation to the cantilever vibration using a pulsed light results in an enhanced response of the cantilever.
