您的位置: 专家智库 > >

国家自然科学基金(50706012)

作品数:3 被引量:2H指数:1
相关作者:王学生代晶晶戚学贵疏敏陈琴珠更多>>
相关机构:华东理工大学更多>>
发文基金:国家自然科学基金更多>>
相关领域:电子电信动力工程及工程热物理理学更多>>

文献类型

  • 3篇期刊文章
  • 2篇会议论文

领域

  • 2篇电子电信
  • 1篇动力工程及工...
  • 1篇一般工业技术
  • 1篇理学

主题

  • 2篇热电
  • 2篇溅射
  • 2篇SEEBEC...
  • 2篇ZN
  • 2篇MAGNET...
  • 2篇磁控
  • 2篇磁控溅射
  • 2篇SB
  • 1篇电导
  • 1篇电导率
  • 1篇温下
  • 1篇纳米
  • 1篇功率因子
  • 1篇NANO
  • 1篇PERFOR...
  • 1篇PREPAR...
  • 1篇THIN_F...
  • 1篇COMPOS...
  • 1篇CONDIT...
  • 1篇HEAT_T...

机构

  • 3篇华东理工大学

作者

  • 3篇代晶晶
  • 3篇王学生
  • 2篇疏敏
  • 2篇戚学贵
  • 1篇从建立
  • 1篇陈琴珠

传媒

  • 1篇材料导报
  • 1篇功能材料与器...
  • 1篇Journa...

年份

  • 1篇2012
  • 3篇2011
  • 1篇2010
3 条 记 录,以下是 1-5
排序方式:
Low-temperatureThermoelectric Properties of Zn/Sb Thin Films Prepared by Magnetronsputtering
The Zn/Sb multi-layer thin films were prepared by magnetron sputtering method,which was sputtered on(100)Si fi...
SHU Min
Zn/Sb复合薄膜材料的制备及其在低温下的热电性能研究
2011年
采用磁控溅射的方法,两个单靶依次在Si(100)基底上循环5次溅射制备了Zn/Sb多层复合纳米薄膜,并研究了固定调制周期为40nm时,Zn和Sb的调制比分别为1:1、3:2和4:1的三种情况下,Zn/Sb复合薄膜的Seebeck系数、电导率和功率因子在160K-250K温度范围内随温度的变化情况。采用XRD、AFM对其结构和表面形貌进行分析,发现制备的薄膜表面光滑、致密,无大颗粒,呈现出晶面择优生长的现象。实验结果表明:当调制比为4:1时,Zn/Sb薄膜的功率因子最高,且其最大值达到在174K时的7543.54μW/mK^2,但随着温度的升高,其值迅速的下降,变化趋势和幅度都很明显。
疏敏王学生代晶晶戚学贵
关键词:磁控溅射SEEBECK系数
Preparation and Research on Performance of Multi-layer Bi/Sb Composite Nano-film
In this paper,the preparation techniques of multi- layer Bi/Sb composite semiconductor nano-film were develope...
DAI Jingjing
多层复合Bi/Sb纳米薄膜的制备及热电性能研究被引量:1
2012年
选取单晶硅作为隔热衬底,Bi和Sb材料作为靶材,采用磁控溅射技术溅射制备多层复合纳米薄膜。研究了当固定调制周期为40nm,Bi和Sb的调制比分别为1∶1、3∶2、4∶1和1∶4时,Bi/Sb超晶格复合薄膜的See-beck系数、电导率和功率因子在160~250K温度范围内随温度的变化。发现当调制比为1∶4时,Bi/Sb薄膜的功率因子明显高于其它3种情况。
代晶晶王学生疏敏戚学贵
关键词:磁控溅射SEEBECK系数电导率功率因子
Pool boiling performance of porous surface tubes under vacuum conditions被引量:1
2010年
Two types of tube bundles are designed,which are,respectively,composed of six tubes arranged in the boiling chamber.The nucleate pool boiling performance of smooth tube bundles and sintered porous surface tube bundles with deionized water as a medium are experimentally studied at atmospheric and sub-atmospheric pressures,respectively.The experimental results indicate that the boiling heat transfer coefficients of the two types of tube bundles increase with the increase in pressure under vacuum conditions as they behave under ordinary pressure.As the pressure varies from 10 to 100 kPa,it also can be seen that the heat transfer coefficient of the sintered porous surface tube is increased by 0.2 to 4 times compared with the smooth one under the same operating parameters.In addition,the experimental data show that a definite bundle effect exists in both sintered porous surface tubes and smooth tubes under vacuum conditions.
王学生代晶晶从建立陈琴珠
共1页<1>
聚类工具0