The performance of inclined pile group embedded in consolidating soil under surcharge load was investigated by experiment in comparison with vertical pile group and single pile under the same conditions; dragload, downdrag, and layered soil settlement were measured. A three-dimensional numerical model was built via FLAC3D software, and verified by the experimental results. Influence factors, such as consolidation time, pile spacing, and pile tilt angle were analyzed. The results show that dragload of inclined pile group increases with the increase of consolidation time and pile spacing or the decrease of pile tilt angle. Downdrag of inclined pile group increases with the increase of consolidation time, pile spacing and pile tilt angle.
Negative skin friction (NSF) is one of the important problems when designing a pile foundation. However, the influence of loading sequence on the dragload and downdrag for pile foundation is seldom studied. In this paper, a three-dimensional numerical model was established using FLAC3D. Compared with the results of model test, the established model could be used to study the NSF of pile foundation. The influencing factors were discussed including the length-diameter ratio of pile and the loading sequence of pile head load and surcharge. A case history was analyzed using FLAC3D. The calculated results are in good agreement with the measured results. It is concluded that the dragload and downdrag are remarkably influenced by the loading sequence of pile head load and surcharge. The dragload and downdrag reach the maximum values under the condition of surcharge after pile head load.
