A novel laminated Al2O3/TiC/CaF2-Al2O3/TiC sandwich ceramic composite was fabricated through cold pressing and sintering to achieve better anti-wear performance, such as low friction coefficient and low wear rate. Al2O3/TiC/CaF2 and Al2O3/TiC composites were alternatively built layer-by-layer to obtain a sandwich structure. Solid lubricant CaF2 was added evenly into the Al2O3/TiC/CaF2 layer to reduce the friction and wear. Al2O3/TiC ceramic was also cold pressed and sintered for comparison. Friction analysis of the two ceramics was then conducted via a wear-and-tear machine. Worn surface and surface compositions were examined by scanning electron microscopy and energy dispersion spectrum, respectively. Results showed that the laminated Al2O3/TiC/CaF2-Al2O3/TiC sandwich ceramic composite has lower friction coefficient and lower wear rate than those of Al2O3/TiC ceramic alone because of the addition of CaF2 into the laminated Al2O3/TiC/CaF2-Al2O3/TiC sandwich ceramic composite. Under the friction load, the tiny CaF2 particles were scraped from the Al2O3/TiC/CaF2 layer and spread on friction pairs before falling off into micropits. This process formed a smooth, self-lubricating film, which led to better anti-wear properties. Adhesive wear is the main wear mechanism of Al2O3/TiC/CaF2 layer and abrasive wear is the main wear mechanism of Al2O3/TiC layer.
Xuefeng YANGJian CHENGPeilong SONGShouren WANGLiying YANGYanjun WANGKen MAO
In order to improve the tribological properties of ceramic composites, Al2O3/TiC-Al2O3/TiC/Ca F2 self-lubricating laminated ceramic composites were prepared by vacuum hot pressing sintering. Experiments were conducted to get mechanical properties and the friction and wear properties were also measured with friction and wear tester. The worn surfaces were observed by scanning electron microscope(SEM) and energy dispersion spectrum(EDS). The wear resistance properties and the self-lubricating effect of ceramic composites were analyzed. Results show that the Al2O3/TiC-Al2O3/TiC/Ca F2 self-lubricating laminated ceramic composites layers are well-defined with a higher bonding strength and the mechanical performances are uniform enough to overcome the anisotropy of weak laminated ceramic composites. In addition, the fracture toughness of Al2O3/TiC layers is also improved. Its friction coefficient and wear rates decrease with the increase of rotation speed and load. Al2O3/TiC-Al2O3/TiC/Ca F2 self-lubricating laminated ceramic composites have good wear resistance because of the tribofilm formed by the Ca F2 solid lubricants. The wear mechanisms of Al2O3/TiC/Ca F2 layers are abrasive wear and Al2O3/TiC layers are adhesive wear.
