In this work,the influence of a small-molecule material,tris(8-hydroxyquinoline) aluminum (Alq 3),on bulk het-erojunction (BHJ) polymer solar cells (PSCs) is investigated in devices based on the blend of poly(2-methoxy-5-(2-ethylhexyloxy)-1,4-phenylenevinylene) (MEH-PPV) and [6,6]-phenyl-C 61-butyric acid methyl ester (PCBM).By dop-ing Alq 3 into MEH-PPV:PCBM solution,the number of MEH-PPV excitons can be effectively increased due to the energy transfer from Alq 3 to MEH-PPV,which probably induces the increase of photocurrent generated by excitons dissociation.However,the low carrier mobility of Alq 3 is detrimental to the efficient charge transport,thereby blocking the charge collection by the respective electrodes.The balance between photon absorption and charge transport in the active layer plays a key role in the performance of PSCs.For the case of 5 wt.% Alq 3 doping,the device performance is deteriorated rather than improved as compared with that of the undoped device.On the other hand,we adopt Alq 3 as a buffer layer instead of commonly used LiF.All the photovoltaic parameters are improved,yielding an 80% increase in power conversion efficiency (PCE) at the optimum thickness (1 nm) as compared with that of the device without any buffer layer.Even for the 5 wt.% Alq 3 doped device,the PCE has a slight enhancement compared with that of the standard device after modification with 1 nm (or 2 nm) thermally evaporated Alq 3.The performance deterioration of Alq 3-doped devices can be explained by the low solubility of Alq 3,which probably deteriorates the bicontinuous D-A network morphology;while the performance improvement of the devices with Alq 3 as a buffer layer is attributed to the increased light harvesting,as well as blocking the hole leakage from MEH-PPV to the aluminum (Al) electrode due to the lower highest occupied molecular orbital (HOMO) level of Alq 3 compared with that of MEH-PPV.
We fabricate inverted organic/inorganic hybrid solar cells based on vertically oriented ZnO nanorods and polymer MEH-PPV. The morphology of ZnO nanorods and ZnO nanorods/MEH-PPV hybrid structure is depicted by using scanning electron microscopy (SEM), X-ray diffraction (XRD), and atomic force microscope (AFM), respectively. It is observed that ZnO nanorods array grows primarily aligned along the perpendicular direction of the ITO substrate. The MEH-PPV molecule does not enter the interspace between ZnO nanorods completely according to SEM picture. It results in the small and bad contact area between ZnO nanorods and MEH-PPV. To improve the photovoltaic performance, we also fabricate another kind of photovoltaic (PV) device modified by N719 dye, and exploit the effect of N719. After the modification of ZnO nanorods by N719, not only Jsc increases from 0.257 mA/cm2 to 0.42 mA/cm2, but also Voc enhances from 0.37 V to 0.42 V. Insert LiF buffer layer between MEH-PPV and anode, Jsc of 1.05 mA/cm2 is obtained, and it is 2.5 times that the device without LiF.