A similitude method to model the tip clearance flow in a high-speed compressor with a low-speed model is presented in this paper.The first step of this method is the derivation of similarity criteria for tip clearance flow,on the basis of an inviscid model of tip clearance flow.The aerodynamic parameters needed for the model design are then obtained from a numerical simulation of the target high-speed compressor rotor.According to the aerodynamic and geometric parameters of the target compressor rotor,a large-scale low-speed rotor blade is designed with an inverse blade design program.In order to validate the similitude method,the features of tip clearance flow in the low-speed model compressor are compared with the ones in the high-speed compressor at both design and small flow rate points.It is found that not only the trajectory of the tip leakage vortex but also the interface between the tip leakage flow and the incoming main flow in the high-speed compressor match well with that of its low speed model.These results validate the effectiveness of the similitude method for the tip clearance flow proposed in this paper.
YU ChenghaiMA NingWANG KaiDU JuanVan den Braembussche R.A.LIN Feng
