A solid state synthesis of ultrafine/nanocrystalline WC-10Co composite powders was reported from WO3 , Co3O4 and carbon powders after reduction and carburization at relatively low temperatures in a short time under pure H2 atmosphere. The effects of ball milling time and reaction temperature on the preparation of ultrafine/nanocrystalline WC-Co composite powders were studied using X-ray diffraction and scanning electron microscope (SEM). The results show that fine mixed oxide powders (WO3 , Co3O4 and carbon powders) can be obtained by long time ball milling. Increasing the reaction temperature can decrease the formation of Co3W3C and graphite phases and increase the WC crystallite size. Long-time ball milling and high reaction temperature are favorable to obtain fine and pure composite powders consisting of nanocrystalline WC from WO3 , Co3O4 and carbon powders.
The yield behavior of metallic glasses was studied. Three yield criteria, including von Mises yield criterion, Mohr-Coulomb yield criterion and the unified yield criterion were used to describe the yield phenomena of the metallic glasses. Two classes of the experimental data were chosen to draw the yield loci using the unified yield criterion. It is shown that the unified yield criterion can be used to describe the yield behavior of the metallic glasses no matter whether the metallic glasses show strength- different effect or non-strength-different effect. Almost all the widely accepted yield criteria are the subsets of the unified yield criterion if the intermediate principle stress and/or the intermediate principle shear stress are not considered at all.
